|
Product Details:
|
| Lead Time: | 15-20 Days | Maintenance: | Maintenance Free |
|---|---|---|---|
| MOQ: | 200pcs | Plate Purity: | 100% |
| Application: | Motorcycle/ATV/Water Craft/Snowmobile | LCD Display: | Optional |
| High Light: | 12V6.5ah Most Powerful Motorcycle Battery,150x87x93mm Most Powerful Motorcycle Battery,12V6.5ah Water Craft Battery |
||
12Volts 6.5Ah High Capacity Sealed Lead Acid Most Powerful Motorcycle Battery
> Features of Factory Activated MF Motorcycle Battery
Are motorcycle batteries AGM or standard?
AGM is the standard battery type. In almost all motorcycles that have sealed batteries, that sealed battery is an AGM, not a Gel.
How do I know if my motorcycle battery is AGM?
Basically, an AGM battery will always have a flat top, and only the negative and positive terminals of the battery will be sticking out.
On the other hand, the liquid acid batteries have a removable top which is not the case with AGM batteries as they are properly sealed.
What type battery is best for motorcycle?
YTX4L-BS 12 VOLT 3AH MOTORCYCLE BATTERY;
YTX9-BS Replacement Battery;
YTX12-BS iGel Replacement Battery;
YTX14 BS ATV Motorcycle Battery;
YTX20L-BS Battery;
YTX30L – MOTORCYCLE BATTERY;
Battery Engine Start Battery;
| Battery Model No. | 12V6.5ah | |
| Nominal Voltage | 12V | |
| Capacity(10HR/25℃) | 6.5Ah | |
| Dimension | Length | 150±2mm |
| Width | 87±2mm | |
| Height | 93mm | |
| Approx. Weight | 2.31kg | |
| Operating temperature range | -20℃-50℃(-4℉-122℉) | |
| Standard charging method(25℃) | Current | 0.9A |
| Time | 5-10h | |
| Quickly charging method(25℃) | Current | 4.5A |
| Time | 1H | |
| Terminal Material | Lead | |
| Container Material | ABS | |
| Component | Pos.plate | Neg.plate | Container | Cover | Separator | Electrolyte | Safety valve | Terminal |
| Raw material | lead dioxide | lead | ABS | ABS | AGM | Sulfuric acid | Rubber | Copper |
> Delivery & Payment Terms
| Payment Terms | T/T |
EXW | 30% in advance for deposit payment, the balance payments will be paid before shipment. | |
| FOB | ||||
| CFR/C&F | 30% in advance for deposit payment, the balance will be paid against copy of B/L | |||
| CIF | ||||
| L/C | For the amount of one shipment above 50,000 usd, L/C at sight is acceptable. | |||
| West Union | For the amount less than 5000 usd |
|||
| Paypal | ||||
| Delivery Time | 7~25 days after receiving the payment or the deposit payment | |||
> How to maintain the battery?
●Check the liquid level regularly, if the liquid level is below the horizontal line. Please fill up to the upper level with distilled water or purified
water in time. Never add sulfuric acid to dissolve waves. After adding liquid, the locomotive should be run for a period of time to make the
electrolyte mixed evenly:
●If the battery has no electrolyte. Or the battery is short of about half of the electrolyte or overcharged, the life of this battery is basically
terminated, even if it can be used after adding the electrolyte, the time will not be too long. . If the battery is in use, there is no battery
solution. It means that if the charging current is too large, the capacity and life of this kind of dried electro-hydraulic battery will be sharply
reduced, and it will even fail directly. .If the battery power is insufficient, please remove the battery to recharge it in time. If the battery is not
charged in time, used for a long time without full charge, etc., it will cause the battery to vulcanize, reduce the battery capacity and shorten
the life, and even the battery cannot be used.
●It should be noted that the battery has been in the state of power for a long time,-part of the active material lead dioxide (pbo2) will always
become dense lead sulfate (pbso4) and cannot be reduced to lead dioxide (pbo2), resulting in a decrease in capacity and a shortened life: If
the battery is not charged for a long time after being discharged, the lead dioxide (pbo2) will become dense lead sulfate (pbso4) and then can
no longer be reduced to lead dioxide (pbo2). This will lead to the end of battery life.
●Even if the battery is in normal use, it must be fully charged by removing the low current from the car during 3.5 months.
●When using the battery to start the locomotive, the starting time cannot exceed 5 seconds each time. If the locomotive fails to start, it must be
restarted after an interval of 15 seconds.
●The battery after filling should be used in time. If it is not used for a long time for some reason, please remove it from the car. Charge it
regularly every month
●Keep the battery clean, keep the exhaust pipe unblocked, and start the locomotive with your foot in the winter morning to increase the engine speed.
> Payment terms:
1. By T/T , 30% T/T in advance,70% before shipment
2. By L/C at sight
3. Western Union, Money gram or cash
> Package details
1. Standard export carton ,then onto pallets, or neutral package
2. If any special requirements on package , it is negotiable
3. All batteries are inspected carefully by QC before shipment.
> Delivery time
1. our lead time is 15-30days on the basis of order quantity after getting 30% deposit
2. if you need samples or small quantity , we can ship battery within 3-7days if we have stock after test is finished.
> Minimum order quantity
1. if battery is smaller than 17ah,MOQ would be 200-1000pcs as per actual battery size if battery is bigger than 17ah,
MOQ would be 50-200pcs as per actual battery size.
2. if order is big quantity or 1*20'fcl load , the price would be much competitive.
Contact Person: Mr. Roger Ning
Tel: +86 139 6163 5976
Fax: 86-512-50176362
